Game Controller

Please make sure the rear gear switch is correct and hold the [Home] button for three seconds until the indicator light flashes quickly to enter pairing mode.
- For dongle pairing: Unplug and reinsert the dongle into the USB port.
- For BT pairing: Unpair the device in the BT settings, turn off and on BT, then reconnect.

Install Flydigi Space Station on your computer Flydigi Ganhe Center on your phone and follow the software instructions to update the firmware.

Install Flydigi Space Station on your computer, enter the the ttesting page, and calibrate the controller as guided.

If there are many 2.4GHz signals in the vicinity, it may cause interference. It is recommended to use a USB extension cable between the dongle and the computer to enhance the signal.

Turn on the controller, press and hold the SELECT+START+HOME keys for five seconds to reset the handle, The RGB light of the controller will dim and light up again (the pairing information will be cleaned)

1. When the controller is connected, press and hold the SELECT key + START key + UP key to enter the calibration mode, and the screen will show "calibrating"
2. Place the controller on a horizontal table for 3 seconds
3. Fully rotate the joystick and gently turn it twice, fully press the trigger and gently press it twice
4. Press the SELECT key + START key + cross key up key (only need once at the same time) to complete the calibration

1. Turn on the controller, long press and hold SELECT+START+ UP key for 3 seconds to enter calibration mode, and the red light will flash slowly (0.5Hz)
2. During calibration, lightly press the left and right triggers twice, and rotate the left and right joysticks twice; (Emphasize not to press the trigger too hard here)
3. Short press SELECT+START+ UP key to exit calibration mode, calibration of the joystick and the trigger can be completed simultaneously.
NOTE: when calibration, you need to keep the trigger in linear staus, not micro.